The only stamping in this one is the sentiment which was stamped in Versamark Ink and heat embossed with white embossing powder from the Basics Embossing Powder set.
My base card is an A5 piece of Basic White Thick A4 folded in half. I have then cut a piece of Basic White A4 card 142mm x 110mm, which I used the scallop edge die from the Penned Flowers Dies on the lower edge before trimming down to be 142mm x 98mm.
Next, I cut a piece of designer series paper 138mm x 89mm and glued this to the Basic White scallop edge piece. I have then die cut the detailed floral image from the Penned Flowers Dies in Basic White and the coordinating solid floral image in Blushing Bride. The detailed image was then glued on top of the solid image. I used Multipurpose glue as I had the detailed image already cut before deciding to use it on this card but the easier option would be to apply a piece of Adhesive Sheet to the Basic White card before die cutting. This has then been mounted to the front layer using Stampin’ Dimensionals.
My next step was to stamp and emboss the sentiment which I have then mounted to the front layer using Stampin’ Dimensionals on the right end and some Multipurpose glue on the flower side.
I have then added an array of Pearl Basic Jewels to the flower centres on the designer series paper before mounting this whole piece to the base card using Stampin’ Dimensionals.